Print Profile(1)
Bill of Materials
Description
I put a “smart lock” on my workshop recently. The design of the "smart lock" however was not so smart. I noticed after it snowed however the snow likes to sit on top of the lock. I know when the gasket goes on this device it's going to be a way for water to get in and force me to buy a new one when it breaks. Just for fun I made this little magnetic roof to stick to my steel door above the lock to keep snow and rain from sitting there. It also keeps the UV from the sun from eating the gasket. There are spots in the back for up to 8 - 8x2mm magnets. I wanted it to be able to stick hard enough it would stay in place if someone slammed the door. You can use it for whatever though like any other fridge magnet. The magnets should friction fit in place, but a dot of superglue behind each one is a good idea.
-Overall length of model is 104mm
Arachne slicing is suggested to get the detail on the round motifs.
Boost Me (for free)
Any boosts are greatly appreciated!
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (12)