Lord of The Rings: Duel Insert / Organizer

If you want, you can help me with designing inserts by donating here:
https://www.paypal.com/donate/?hosted_button_id=J2YS7MREH8MU8

or joining my club here:
https://www.printables.com/@Sortirus_659392#join.@Sortirus_659392.1094

Hello,

for those that don't know my ‘insert philosophy’ - I am creating modular inserts that are focused on reducing setup and space on table, filament consumption is not my highest priority, but of course I'm trying to save some material where I can.
 

Important Notes:

• My prints take a lot of time to print. Why? First of all, to save filament, electricity price is much lower than filament price (at least in my country). Second of all - total weight, if it's to high it can damage the box and our spines :D + weight also influence vertical storage, box can open by itself,
• Clearence for holder covers is very small - 0.2mm horizontal, make sure that you have calibrated printer. In worst case - you could add like 0.2-0.4mm to cover width in the slicer.

Supports:

• vertical storage,
• sleeves - for sure 70 microns, I think 100 microns can also fit, but I don't have them, so I can't check. There is plenty space though,
• promo tiles - additionally to 2 promos - there is space for at least 2 more.

This insert features:

• Player_Components_Holder_x2 - for player components (wooden pieces),
• Holder- for everything else. Built-in storage for coins (with cover) and alliance tokens. Best to take the whole holder out and put it on the table.

Requirements:

• about 250g (depends on your settings, I printed with 15% gyroid infill, 2 walls, 5 top and 3 bottom layers), 
• at least 196mm x 194mm print bed.

Instructions:

Supports - no supports required.

• every file ended with xX (for example x16) - print X times (in given example - 16 times).
   

What future holds:

• I will update the insert if/when expansion comes out.

Enjoy!