Sand Wolf Shiroko Missile Drone

Introduction

A White Son's missile drone This model is built from scratch according to the official setting collection, featuring a missile ejection mechanism and retractable landing gear

Note (The ejection mechanism requires the additional purchase of eight compression springs <Specifications Wire diameter: 0.5 Diameter: 6 Length: 35>)

For some parts that feel too tight, please use low-grit sandpaper to smooth them before assembly (Redundancy has been removed in the new version)

Preparation

Nitrile gloves*1, spatula*1, 502 (or 416)*1, sprue cutter*1, fine-tipped tweezers*1, 60-grit sandpaper*1, hammer*1 for removing supports, trimming, hammering parts into place, and joining parts

Compression springs (Wire diameter: 0.5 Diameter: 6 Length: 35)

Partial Design Review

Assembly Instructions

【Sand Wolf White Son - Missile Drone - 3D Printed Movable Product】 https://www.bilibili.com/video/BV1zscBePE8C/?p=2&share_source=copy_web&vd_source=27a7aaf7dd74009455254993fc393de2

Assembly Update and Errata

(2025/2/15)

For the part shown below, it is strongly recommended to insert only two arrow pins; inserting all of them will impede proper missile insertion