Search models, users, collections, and posts
Feeder for small hens / Feeder for small hens
IP Report
Print Profile(0)
Add the first print profile to earn points
Boost
21
47
0
2
68
5
Released
Description
Tisknuto po částech.
Nutno použít navíc šrouby a matice M4, M5, M6.
Netisknul jsem přední a zadní stěnu a dno. Použil jsem na to materiál který měl cca 1,7mm, takže předpokládám, že by bylo nutno tyto STL.
Printed in parts.
M4, M5, M6 screws and nuts must also be used.
I did not print the front and back walls and the bottom. I used a material that was about 1.7mm, so I assume that these STLs would be necessary.
https://youtube.com/shorts/b6-_XkpQZj4?feature=share
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)