Search models, users, collections, and posts
Gridfinity A1/ A1 Mini Toolbox
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 10% infill
Designer
2 h
1 plate
Open in Bambu Studio
Boost
81
243
69
14
357
261
Released
Description
Really like this model by shork
Personally didn't need the holes in the bottom for magnets as im using the lite gridfinity base. I remixed the holder but without the magnet holes in the bottom this also made the printing a little Faster just over 2 hours for me
feel free to upload your prints
Thank you
Please leave feed back and ratings, upload any pictures of the models so everybody can see your prints. Receiving feed back is so encouraging, it makes modelling even more enjoyable.
Check out the other models on my profile
Boost Me (for free)
Boosts are free, like a virtual fist bump so if you could I would really appreciate it :D
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (69)