Search models, users, collections, and posts
Dartboard Bracket
IP Report
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
24 min
1 plate
flat, 0.2mm layer, 3 walls, 20% infill gyroid
32 min
1 plate
Open in Bambu Studio
Boost
19
33
8
2
89
69
Released
Description
Hi,
Here you have a basic dartboard bracket.
It is printed in a angle so that the bracket is stronger when tightening the screw.
Please print with support.
I used tree support for the print, any support should be fine.
Be carefull when attaching the bracket on the wall.
You should just touch the bracket with the screw so that the bracket does not move anymore.
also pleaase use the correct plugs for your wall.
Have fun.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (8)