Spacex Launch Tower /OLM Pad B / Starship 1:100

This is the launch complex for the Superheavy Booster / Starship Pad - B

Since the launch infrastructure does not yet fully exist, the construction is partly based on assumptions and will be updated over time

It is a rather demanding and large project that requires a lot of printing time and material

But it's worth it in my humble opinion

All print plates are labeled so you know what you are currently printing and can assign it better

Just for your information, the tower segment on plate 24 must be printed 5 times. Which segments these are is indicated on the print plate

Assembly instructions are available below

Update

A few things have changed

The height of the SQD has been corrected downwards by 55 mm, which is why the arrangement of the tower sections has changed

Sled, catch arms, and SQD have been revised and expanded

The retaining clips in the OLM have been modified and fitted with springs to make it easier to insert the booster with the newly created insertion aid

Update 06.06.2026

The design of the QD-Hud's has been adapted

Retaining clip system was changed and covers added

Shields for tower roof were added

Side doors were indicated on the utility building and ventilation shields were added

Have fun building it

To fix the catch arms at a certain height, I added this clamp, it is on plate 35