Search models, users, collections, and posts
DarwinFPV FoldApe4 Front Plate
IP Report
Print Profile(2)
0.12mm layer, 2 walls, 15% infill
Designer
10 min
1 plate
TPU Profile, slower speed
Designer
13 min
1 plate
Open in Bambu Studio
Boost
5
8
1
0
16
3
Released
Description
This is a GoPro mount replacement for the DarwinFPV FoldApe4. This is printed in PLA, but I imagine it could be printed in TPU, PETG etc as this is not a structural part. This is just to replace the GoPro mount if you dont need it and want to save some weight. This also allowed me to easier fit a larger 1500mah 3S battery.
Printed at the 0.12mm Fine setting for PLA, as I wanted to make sure the fit would be to spec. This still only takes around 5-10 mins to print depending on your settings.
This is also the base plate I will be using to design a GPS relocation as the GPS placement from the factory is poor.
Feel free to message me if you want to know more, or would like the Fusion360 file.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
Comment & Rating (1)