PS1 / PS2 Replacement Thumbsticks | Dual Color AMS
Print Profile(2)
Description
Boost Me (for free)
Boosting is free, and supports me just as much as a membership! Your points go straight to my filament and printer part costs, fueling more dope models like these!
Replacement Joysticks for Dualshock Controllers!
Found this decent thumbstick model by Cecche on Thingiverse to replace the old ones on my Dualshock 1 controller, but upon printing it I found some of the measurements were so off I couldn't even get them on. I've since changed the shaft hole size and length to perfectly accept these onto the sensors without any dragging and without trimming or sanding. They're just as easy as swapping out!
Obviously they're not as grippy as the old ones after I printed mine in PETG, but they're still usable and a definite upgrade over melting rubber. In the future I may also add a divot in each center pad along with textured bumps for better grips. Haven't properly tested these with Dualshock 2s but multiple users have now confirmed it's not compatible with Dualshock 3s, so keep in mind you may need to do a little trimming or sanding if you intend to use them for those versions. Dualshock 1s are tested and fully compatible however. Stay tuned for future improvements!
Membership
your contributions as a commercial member both give me the financial incentive to continue creating valuable designs, while also providing you with the opportunity to resell parts and models to hobbyists without printers!
This remix is based on
License
Comment & Rating (15)