New Year Refrigerator Magnets Set Two (13 pieces per set)

-----————Updated on 2026.1.9————————————————————

1. The embedded magnet version has been mainly adjusted, with the original 2 magnet holes increased to 4 to enhance magnetic adhesion.

2. The thickness of the negative magnet part has been adjusted from 2.2 to 2.

-----————Updated on 2025.12.28————————————————————

Given that many people said the magnets were difficult to install, adjustments were made.

1. The size of the negative part has been re-adjusted; the magnet hole is currently 5.2*2.2mm.

2. The previously messy parts were organized, parts of the same color were merged, and the naming was revised.

3. The prime tower was removed.

4. Added a filament change pause configuration (print profile two)

It has been released in print profile one. Others are pending adjustment.

————————————————————————————

Print directly with AMS;

Without AMS, pause for filament change, add a pause at layer 16 (you need to add the pause yourself in the slicer software);

The negative part used for the magnet installation hole can be modified by yourself to fit your magnets; the model uses magnets with a diameter of 5mm and a thickness of 2mm;

There are two options for setting the installation hole:

1. The negative part size is the same as the magnet size, then tap the magnet in with a small hammer; (convenient)

2. Increase the diameter and thickness of the negative part by 0.2mm compared to the magnet size, then glue it on. (less effort)

The image below is the first set, with 10 items, which can be viewed on the homepage.