Lego Brick Plates (2, 4, 6 and 8 studs)

Here you will find various Construction Plates (stackable underside) compatible with plug-in systems and standard-sized building blocks. Due to various offsets in the CAD design, using the stored profile on my printer with Bambu Lab PLA+, I achieved very good clamping performance for my building blocks (both on the top and on the bottom) (a friend was able to reproduce this with the same profile and PETG)

For other sizes, just ask or create them yourself using my OnShape design (see below)

You can find more building blocks in my profile - more will be added successively - if you need a specific building block, just message me

However, the diameters of the studs and lower cylinders can vary depending on the print profile, printer, and filament. For this reason, I have also created a test plate with different diameters, which you can print with your setup and determine the appropriate diameter, at least for the studs

With the value thus determined (or simply the measured differences in diameters relative to your building blocks), you can create a copy of the CAD design in OnShape and easily specify the required diameter there. In addition to the diameter for adjusting the clamping properties, the number of required rows/columns of the plate can also be easily specified here, and the corresponding model will be automatically generated

The exact procedure for creating your own plate based on a configurable OnShape design (released for copying and adaptation) can be found in the documentation (pdf) attached to the Project for the base plates outlined for a base plate - however, the procedure for the stackable Construction Plates is identical.