Search models, users, collections, and posts
Print profile TPU ERYONE
IP Report
GIF
Print Profile(1)
0.2mm layer, 3 walls, 0% infill
Designer
1.5 h
1 plate
Open in Bambu Studio
Boost
621
1345
280
24
4.3 k
2.3 k
Released
Description
I tried to create these print profiles for TPU eryone , the result is quite good
a piece of advice I can give you:
do not put the external spool on the original housings of the printed items, it creates a lot of resistance in pulling the filament, if you have a dryer or a stand for spools use that the filament is not "pulled" so you have a much more regular extrusion and you do not run the risk of modifying the diameter of the TPU…I hope it is useful
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (280)