Search models, users, collections, and posts
Riser for Samsung TV
IP Report
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
12.8 h
1 plate
Open in Bambu Studio
Boost
36
87
0
0
96
7
Released
Description
Samsung 32" TV QN32Q60AA risers to lift the TV about 76mm (3") off the surface where it is set.
We have a small TV on the dresser in our room that needed to be a few inches higher to be seen over my big feet. These risers fit the need. The TV legs set in the trough. This uses a fair bit a filament, but it's a single-time print for me and I wanted a sturdy platform. $7 in filament is better than $300 on a TV if it tips off
Print in PETG, on its side, no supports
Glue non-slip shelf liner to the bottom
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)