Print Profile(1)
Description
READ HERE
Assembling the lamp is quite straightforward, however, pay close attention to the pins. One of the two pins has a shorter top face (I’ve outlined it with a small engraved cube)
For optimal results:
First, position the larger pin
Next, insert the pin with the shorter top side, placing it adjacent to the first
!!!Note!!! that the shorter side must face the already assembled pin
This detail is necessary to rectify a slight design oversight which would otherwise prevent the pin from sliding completely to the bottom (it would be blocked by the other):
I glued everything together using a suitable adhesive to keep everything securely fastened
For illumination, I used a 1m LED strip, which I trimmed to fit the lamp perfectly
Place the LED strip inside the rear ‘’lid’’ of the lamp
Thank you for your attention, and if you enjoyed the project, please consider supporting me by leaving a like, a comment, and a wonderful boost 😁
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (5)