Jesus Christ on the Cross with a base

This is a remix of the sculpture of Jesus on the cross by Baccio da Montelupo (1469-1535), this large wooden work depicts Jesus upon the Crucifix. It was scanned by Scan the World. I flipped it, changed the infil, fixed the supports, then merged it with a display base by Shangyu_wang located here.

This is a perfect model for placing on a desk or bookcase. It will scale extremely well, and can be printed with any PLA.

I HIGHLY recommending printing on normal or silent mode. Going faster will make the sculpture not look as good. Additionally, you have to be patient with removing the support trees. Start by lightly separating the brim at the bottom. Then slightly break each of the top most trees. Once those are individually broken, you can loosen up and remove the ones at the foot. BE EXTREMELY CAREFUL with these. Be patient and break them one at a time. If you are patient and methodological you can get them all off with no tools in 3 minutes without breaking the model or leaving scars.