3xAA Battery Box with Snap Lid

I designed this box for 3 AA batteries. It can be easily installed in a 60x68mm hole. It can be fixed with glue.

Print settings:

• layer height: 0,2
• infill: 30%
• support: yes (Normal)
• brim: yes (manual, recommended for the top of the box)
• meterial: PETG

Similar model: 

• 4xAA Battery Case with Snap Lid: https://makerworld.com/en/models/2551123-4xaa-battery-case-with-snap-lid#profileId-2809634
• 2xAA Battery Box with Snap Lid: https://makerworld.com/en/models/1824784-2xaa-battery-box-with-snap-lid#profileId-1948022
• 1xAA Battery Box with Snap Lid: https://makerworld.com/en/models/1843941-1xaa-battery-box-with-snap-lid#profileId-1970360
• 1x18650 Battery Case with Snap Lid: https://makerworld.com/en/models/1956199-1x18650-battery-case-with-snap-lid#profileId-2102412
• 3x18650 Battery Case with Snap Lid: https://makerworld.com/en/models/2505747-3x18650-battery-case-with-snap-lid#profileId-2754978
• 4x18650 Battery Case with Snap Lid: https://makerworld.com/en/models/2532968-4x18650-battery-case-with-snap-lid#profileId-2787859

UPDATE 24.09.2024: 

• I added a model where I strengthened some weak points. This model was named 2.0. 
• I also added a new Print Profil with PLA as support material. 

Here is a printing guide for using PETG and PLA for support: https://wiki.bambulab.com/en/filament-acc/filament/h2d-pla-and-petg-mutual-support

Love the design? ⚡ Support my filament fund:  https://buymeacoffee.com/filafun