AMS Enclosure Door Sealing Moisture-Proof Enhanced Fastener
Print Profile(2)
Description
For a long time, I've observed a small gap often appearing when the AMS enclosure door is closed due to the lack of a latch. Recently, I decided to design a fastener to address this minor issue. After printing, install it using two 1.5cm lengths of filament. Slightly bevel the ends of the filaments; insert and press against the edge of the table to complete installation.
Installation on the enclosure door handle can be achieved by slightly forcing it in with a bit of skill using the angle shown in Figure Two, or by removing the handle screws before installation.
Two locking force options are provided. When the fastener base is facing upwards, the locking force is smaller, and vice-versa.
If you wish to add a logo, please add it yourself (the version with the logo added resulted in a gcode error, preventing upload).
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (6)