Search models, users, collections, and posts
Nitecore HC33 flashlight cover
IP Report
Print Profile(1)
0.2mm layer, simple
Designer
24 min
1 plate
Open in Bambu Studio
Boost
1
3
0
0
4
1
Released
Description
This is a cover for Nitecore HC33 headlamp, for an even lower light output. I.E. map reading, where the red filter would skew the map colors, and no filter would be too bright for the eyes.
The cover is designed to be put on while one of the OEM filters is turned to the side, as the process of changing filters is lengthy and tricky in the field.
It works when printed with PLA, however with higher light output settings, the front of the filter gets soft, so I'd recommend PETG.
After printing, remove supports and clean the light hole.
To put the cover on the flashlight, put the rear of the cover in the slot for the radiator and slide the front on.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)