Search models, users, collections, and posts
Kallax drawer Gridfinity plate w alignment points
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 10% infill
Designer
2.8 h
4 plates
Open in Bambu Studio
Boost
3
7
0
1
15
6
Released
Description
This model is based off the model by JacenToth. I found that it was much easier to assemble the baseplate with the alignment points. There are 2mm diameter points for insertion of a small piece of filament. While I tend to glue them together, you may find that is not needed, depending on your own situation.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)