Search models, users, collections, and posts
Lincoln Logs Complete Set
IP Report
GIF
Print Profile(3)
0.2mm layer, 2 walls, 15% infill
Designer
4.6 h
3 plates
0.2mm layer, 2 walls, 15% infill
Designer
2.8 h
2 plates
0.6mm nozzle, 0.3mm layer, 4 walls, 25% infill
Designer
4.6 h
3 plates
Open in Bambu Studio
Boost
177
580
29
16
420
208
Released
Description
This is a complete set of Lincoln Log compatible parts. Mix and match as needed. I'm excited to see what you build!
included are:
- 1 notch log
- 1 notch log base / half
- 2 notch log
- 2 notch log base / half
- 3 notch log
- 3 notch log base / half
- 4 notch log
- 4 notch log base / half
- Chimney
- Roof supports
- 3 notch shingle
- 4 notch shingle
You can print these quickly with no supports. I used wood PLA and printed everything with 5% infill and .3 layer height since there are not any complicated patterns. One change I did make over the original Lincoln Logs was to trim the height a little bit so it removes some of the material to make them a little more stable than the original logs.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (29)