Search models, users, collections, and posts
8xPlier-Holder (screw into board) low filament 28g
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 10% infill
Designer
1.2 h
1 plate
Open in Bambu Studio
Boost
32
64
9
3
102
73
Released
Bill of Materials
Bambu Filaments
Select all
Description
Modified version of plier's holder from “SimplisticShapes”, made option to screw into the board, used negative modifiers for holes so you can match needed size also modifier is used for back plate so either you go low filament mode like I did, or you can print full back wall to use double sided tape to stick to some other surface.
Very low amount of filament is needed for my version, only 27grams !
Material used: Jayo PETG Black
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (9)