Search models, users, collections, and posts
Very Useful Magnets (Fidget/Utility)
IP Report
Print Profile(1)
Rectangle, 8x2mm Magnets | 0.16mm layer, 2 walls, 15% infill
Designer
18 min
1 plate
Open in Bambu Studio
Boost
2
3
1
1
8
3
Released
Description
VERY USEFUL MAGNETS
Assembly
The print will pause at Layer 19*
Firmly place each magnet into all 12 holes, and press them in.
IF YOU DONT PRESS THEM FAR, THE PRINT MIGHT NOT WORK
If the print fails, find a layer that is higher than the rest, and pull it up. It should remove the top.
More sizes and shapes coming soon!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)