The Eiffel Tower: One-piece, No support, 7" print

Update 8/27/2025** 

After quite a bit of comments/requests regarding stringing on the bottom side of the tower I decided to run a few print iterations that include some minimal supports in the critical areas. This supported print profile is now loaded so please take a look and if the stringing on your original model was too troublesome give this new profile a try! Thank you all for the continued support on this model! (Both the 100% and 130% scale profiles now have a Supported print profile*)

The Eiffel Tower replica with a no-support print profile. Some of the small details have been slightly enlarged to allow for easy printing with a .4mm nozzle. The provided print profile is for a .16mm High Quality print profile and prints nicely in multicolor PLA Silk.

Also available in a 130% scale, support-free, single-part print profile (0.2mm layer height). 
 

 If scaling to smaller than 100% consider bumping up layer resolution to .12 or .08 mm High Quality print profile as well as changing over to a .2mm nozzle for better detail resolution. 
 

The 100% scale print results in approximately 7.2 inch tall tower, the 130% scale print yields a 9.5" tall model.

UPDATE* Additional sizes/colors now available! 

Some of my other variants of the Eiffel tower can be found here!:

• 3-piece, 200% scale model: https://makerworld.com/en/models/1067918#profileId-1057183
• 1-piece, 50% & 25% scale model: Eiffel Tower Mini! 1-piece, No support, 3.5" & 2" by C0bl3rG0bl3r - MakerWorld
• 1-piece, 100% 3-color ams model: https://makerworld.com/en/models/1071421#profileId-1061385 

Thank you for visiting my page and taking the time to print my models. Your support is truly appreciated. I never expected to have so many people following me and fueling my passion for creating the models that I create!