Search models, users, collections, and posts
Small Unicorn with Wings
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
2.2 h
1 plate
Open in Bambu Studio
Boost
40
88
8
3
119
69
Released
Description
Small Unicorn model created and 3d modeled with Gemini AI and Makerlab Image to 3d.
Profile is tweaked using max volumetric speed calculation in the filament profile to slow printing speed down to 70mms.
Nozzle temp set to 210 and bed to 55 to match most generic PLA. Adjust to match your filament.
Supports should be carefully removed with snips and long nose pliers. Special care around the tail is required.
Snip off the top tail support and then split and remove the back of the bottom support and the rest should slide of of the tail tip.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (8)