Push-type toothpick dispenser (ejectable, no hardware needed)

Existing toothpick holders are often merely boxes, requiring manual opening and retrieval, which is unsanitary and inconvenient. Roller-type dispensers, on the other hand, consume excessive material and occupy considerable space. Therefore, I created this press-type toothpick dispenser!

Weighing only 43g!

Each press of the button dispenses a single toothpick, similar to other press-type dispensers.

I also incorporated a toothpick launching function. Considering this is not a standard feature, I've included it on the second print plate in the print settings. I must stress: never aim the toothpick launcher at any person or animal!

Theoretically, the dispenser only needs one button. However, considering the degradation and inconsistent elasticity of plastic springs,

I've added a second button. This allows you to reposition the toothpick clip without opening the lid, even when the spring is no longer functioning effectively.

This model has undergone more than 20 iterations, requiring significant effort. I earnestly request your support, and I'm deeply grateful for any assistance.

High-strength, high-tenacity materials like PETG are recommended. Avoid brittle filaments.

Assembly Instructions

Locate these two long strips and hold them as shown.

Insert the toothpick clip into the hole.

Note that the clip has a top and bottom, distinguished by the rotating shaft: narrow end up, wide end down.

Then insert the stop.

Insert the spring with the protrusion facing down into the slot shown.

Insert the assembled part into the recess shown.

Attach the buttons. There are two types; one with half of the bottom missing, this goes on the left.

Finally, add toothpicks, close the lid, and you're done.

For a more detailed visual guide, download the comprehensive assembly instructions.

This is part of a larger plan.