Pirates of the Caribbean Wall Sign

Show off your Disneyland or Disney World love on the wall of your room or office! No better way to do it than to rep the greatest ride in the parks!

Final dimensions: 27 cm x 15 cm x 5mm

It works great with a 0.4mm nozzle and I just printed it in black, red and white PLA as listed below. 

Two Print Profiles:

1. Original - This is the first print profile for this sign, which works great

2. Improve Surface Texture - This adds a soft texture to the top black surface to make the sign look better in certain light and to hide a lot of the print lines left behind by the nozzle

    

If you like Disneyland décor, check out my Disneyland Logo Lightbox

NOTE: This can be a challenging print, but if you follow these suggestions carefully, it'll turn out great

The main issue is bed adhesion on the first layer and occasional warping on the corners. For the best results and to avoid any failed prints, I highly recommend doing all of the following:

1. Clean your build plate thoroughly before starting
2. Use a very slow first layer speed, something like 15-20 mm/s (this is pre-configured in the print profile)
3. Watch the first layer to make sure it adheres properly. If it succeeds, then the rest of the print should as well.
4. Once the print succeeds, leave it on the build plate for 15-20 mins so it cools completely before removing it. Removing prematurely may result in a warped sign.

If you follow the steps above, you'll have a great sign that will look great on any wall :)