Fast grip gunstock for quest 3

This gunstock is comfortable and lightweight for fast games.
* The halved front grip enables you to grab and release your weapon very fast.
* The bend middle makes it easier to reload weapons
* The quite short front and low weight makes it easier to keep the stock on while using it one-handed.

How to assemble:

Put both parts into each other (may sand them if needed)
Then you will need to carve the small sides of the pin with a sharp knife, till it fits tightly into the hole! (from the bottom)
(This way you always get a strong fit, no matter what tolerances your printer/filament needs.)
(If you think the Pin could fall off, you can pour some glue into the hole first.)

Update 1:
* I added a front half with closed front grip as optional alternative. (user wish)
* bottom edges are more flat for cleaner prints.
Update 2:
* Added 2 print profiles for 7cm longer front parts (also with alternative grip from Update 1)
Update 3:
* Adapted original model to fit into A1-Mini (by splitting them)
* Adaption for long version TBD