PINECIL ALL-IN-ONE CASE (SS-02 / Heatset / Flux)

It's very hard to find a case that fits all our needs when it comes to a Pinecil case. So I got a lot of stuff I liked and stitched them all together with my own touches. 

Hardware needed:

• 6 x M3x20 screws for the hinges and latch.

This case accommodates:

• Pinecil (+1 in the Solder iron itself)
• 10ml syringe or 5ml syringe
• SS-02 Solder Sucker
• 5 extra tips (Long or short ones)
• Heat set tips kit
• 2 reels (for Solder)
• A Stand
• Brass/Wet Sponge
• A short cable

This project uses the following designs as its base:

• Wide (3 Slots) Case and the Stand from @TheCafeRacer
• Reels from @Termiman
• Heat set insert kit from @Govido
• SS02 Slot from @Jamie Xu

Even after all those together I still didn't reach my go. I had to add a 10ml syringe slot and adjust the tips holder to accommodate not only the short tip version, but also the long one.

I also added a 5ml (or as some call, 6ml) syringe version.

Remember, you can get points to trade for filament yourself by just reviewing print profiles. Up to 10 points for each review if you are one of the first 5.

If you have any suggestion or feedback, please leave a comment or message me.