Search models, users, collections, and posts
Singer accessories box
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
6.7 h
3 plates
Open in Bambu Studio
Boost
21
65
5
2
47
12
Released
Description
This is a box similar to the box that came with Singer 500 sewing machines to store the accessories. You can see a description at this page:
The inner tray has been drawn up already by Robatron and is available on Thingiverse:
https://www.thingiverse.com/thing:4580703
The hinge uses filament to secure the two halves - you might need to use a pair of pliers to gently push it in. The clasp has been replaced with two 6 x 2.5mm magnets, which do a reasonable job of holding the lid down. I printed it with Bambu Labs PLA Basic using the built-in profile with gyroid infill and a 10mm brim.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (5)