Web Shooter Bullet

Some one on another post mentioned that they needed a replacement piece for this webshooter bullet. After reviewing his measurements I made this interaction of a replacement. PRINT WITH SUPPORT ON ITS LENGTH. Usually, I would say to make a flat side to print without supports but since this is intended to work on an external piece printing it with supports enabled isn't that bad. This was designed to have a 6 mm x 4 mm magnet inserted into it. To insert it simply tie the rope on the end like the previous version. I use a fisherman’s not but use any not that works for you. 

If you like this model and the explantion behind it please leave a comment and like to boost the algorithm, Thanks :)