Search models, users, collections, and posts
Cash Gift Card
IP Report
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
58 min
1 plate
Open in Bambu Studio
Boost
38
58
11
2
143
71
Released
Description
FREE COMMERCIAL LICENCE
Boost Me (for free)
If you like these then send me a boost to keep things FREE
When you are not sure what to give a person as a gift or the gift cart they would want give The Cash Gift Card!!
This prints in two parts and then snaps together so no support required. If you change the text colour ensure to put the card face down to print.
Preset profile from BBL
0.16mm Optimal
Uses snaps (std setting from BBL Slicer) to click together very tight fit (I used plyers to put together)
I used the textured plate for best adhesion and no warping. I have had sucess (not 100%) using the smoothe patterend plate but only the front as the back will warp.
Tested with a £20 note $10 bill.
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (11)