Playmobil 3225330

Update 20251009:

The left end cap with the detent and the detent lever itself were added by request

The model now includes the entire lifting device

Update 20250513:

The matching retaining clip was added by request

2 versions are included One is 100% original and the other is optimized for printing without supports

Both variants can be seen assembled in the picture

Both fit and I see no difference, so a recommendation for the print-optimized variant

Replacement part for Playmobil drawbridge

Model number of the crank axle 3225330

I do not have the number for the right end cap as it was missing

I did not find a replacement part at this cost

Check suitability using the drawing dimensions

• Printed in PLA
• Cap clicks neatly into place and holds without glue
• Tree supports minimal, were easy to remove,
  my top Z-offset of 0.18 was perfect, test your own preferences
• I replaced the crank itself with a better printable wheel, multi-toothed