Action Multicolor Wall Light WLED conversion

https://www.action.com/de-de/p/3015639/mehrfarbige-wandbeleuchtung/

You need:

• A soldering iron.

• Carpet knife, or another sharp thin knife.

• wire stripping tool.

• the WLED Controller 12-24V-GL-ML-002WL 

• (optional) Self-adhesive Velcro

1. Take the original RGB controller.
2. Open it along the seam. (With a sharp knife, but carefully)
3. Remove the four screws and the contact board. (Don't throw away the screws, we still need them)
4. Take the WLED controller, remove the connection plug and the white sheathing. Carefully open the cover for the next step.
5. Remove the remaining white sheathed cables
6. Carefully pull off the white rest without damaging the other cables.
7. Cut the cables to a suitable length so that they fit into the housing. Desolder the contact board from the original controller and solder it 1:1 to the new WLED controller with the same orientation.
8. Insert the WLED controller into the housing.
9. Insert the contact board into the housing.
10. Take the back cover and close it with the four screws. 😉
11. Glue a suitable piece of double-sided adhesive tape to the back of the button.
12. Fasten it in the middle. 

13. Adopt my configuration⬇️.

    Go too Config → LED Preferences → Maximum PSU Current: too

    3000

     mA

     

    Under: 

    Hardware setup →

    LED outputs:

    LED Typ: WS281x

    mA/LED: 30mA (typ. 12V)

    Length: Long segments have 5 ledes the small ones 1 one. Add them all together and enter the result.

    Color Order: RGB

     

14. And you're done😊🤙.