Timberland style Boots for Urban Bunny

I decided to make a set of Timberland style boots for the beloved, viral Urban Bunny model by Mohrins. These look great on the original bunny or any of the other character variants that use the same shoe connection. 

You are welcome to sell the prints, too. I just ask for attribution.

I originally had a standard lug style boot tread on these and I found that they were unreliable to print and a huge pain to weed the supports even when they managed to print ok -- so I went back to the drawing board and got rid of the tread. I may revisit this in the future to try and make a reliable tread design, but for now – this is the best bet.

Colors used in photos - Polymaker Polyterra Wood Brown, Polymaker Polyterra Earth Brown, eSun PLA+ Black, RongTong Matte PLA Beige/Bone. Any similar combination should look legit. They also look great in all black.

You should glue them onto the legs/pants for best stability. You should do this with any of the shoes for these guys, but I know some folks don't. I've had them standing up with these on for a few days without it and they will stay if you're careful, but they do tip out of the boots easily. I kept the post a bit loose so you could fine tune the angle, I can make a tighter fitting post if anyone wants it – let me know and I'll upload a print profile.