Search models, users, collections, and posts
Print Profile(1)
0.2mm layer, 6 walls, 15% infill
Designer
3 h
1 plate
Open in Bambu Studio
Boost
12
37
0
0
13
8
Released
Description
Boost Me (for free)
If you want to make me happy
I just did this for my girlfriend so that it looks good. I know it's not very practical, but it will withstand very heavy loads.
If the screw doesn’t go in properly, use a hairdryer to heat the area and then screw it in quickly. This also applies to the ribbon, but it doesn’t need as much heat.
This project was just sitting on my laptop, so I thought I’d share it.
Boost Me (for free)
If you want to support me.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)