Search models, users, collections, and posts
BMW Z3 Seat Tilt Support
IP Report
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
1.1 h
1 plate
Open in Bambu Studio
Boost
8
24
1
2
18
9
Released
Description
Support for Z3 Thayer Seat Tilt Kit. low cost kit i found on amazon focuses force onto a small point on the cars floor that i am concerned will break due to fatigue stress over time.
utilizes all components from the Kit. install small washer, standoff, and stud as instructed then slide the printed part over before the 2 washers between the standoff and seat.
Print with ABS(material most plastic parts in car are made of), ASA (recommended), or PETG.
DO NOT USE PLA; it can soften and will not provide any support especially if living in a warm place.
will probably fit most seat tilt kits similar to this one i used:
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)