Search models, users, collections, and posts
Crokinole Disc Holder
IP Report
Print Profile(7)
0.2mm layer, 2 walls, 15% infill - PLA Support
Designer
1.9 h
1 plate
0.2mm layer, 2 walls, 15% infill - PETG support interface
Designer
2.1 h
1 plate
8 disc holder - side mounted
Designer
2.2 h
1 plate
6 disc holder - table top version
Designer
1.3 h
1 plate
Click to see more
Open in Bambu Studio
Boost
46
146
39
16
125
95
Released
Description
I recently purchased a crokinole board but it did not come with anything to hold the buttons / discs on the side. So I designed this holder that sits on the side of the board. I made it to only hold six so that you can divide them easily when playing 2v2 or can have 2 on one side when playing 1v1.
I recommend putting .25 inch wide adhesive felt on the bottom so it doesn't cause unnecessary wear on the board.
I have provided profiles for printing the support interface in PETG so the bottom side is very clean but also a profile for standard support options.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (39)