Adjustable graphic card holder Nvidia Geforce RTX
Print Profile(2)
Description
Min. height 71mm
Max height 118 mm
Instructions:
I set print by object method because different layer heights and ironing.
Main item (bulid plate 1)
0,2 mm layer height
Ironing on top surfaces (I set 35mm/s and 30% (I think the correct setting depends on the printer and the type of filament)
Only a minimal support is needed for the bottom.
Inner rod (build plate 2)
0,12 mm layer height
no ironing
Boost Me (for free)
An 8x2 mm magnet can be placed in the bottom.
On a flat surface, push the magnet in to make it nice and flat. Minimal superglue can go into the hole.
If you spray a little PTFE or similar lubricant inside the thread, the rod will rotate much better.
High-speed printing is not recommended due to fine details, acceleration speed decelerated.
It probably won't work if resized.
Check out my other uploads and download and print them. RTX, Aorus, AMD, TUF, ROG, BO6, Minecraft, CS GO
!!! Make sure the print speed and temperature and cooling are set correctly for your printer and the filament you are using !!!
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (42)