Toy Train Screw Elevator: BRIO & IKEA Compatible
Print Profile(2)
Description
A simple train elevator using the principles of screws.
Asembly:
1) Insert the rail into the main body; do this by rotating it 90 degrees horizontally and sliding it in
2) Place the two screws through each hole, align with the rail spin them/tighten them until they are on an equal level to each other and the rail is flat.
3) Slightly Lift them up and slide the handle gear into the gap. Make sure that the extruding gap perfectly fits with the hole in the main body.
4) Align the teath from each gear with the handle gear.
5) Screw on the end caps (the two small cylnder thingies) under the main body to prevent the screw element from moving vertically.
6) Optional: add stopper rail to one of the sides.
Make sure that the screws print horizonally; this increases layer adhesion and prevents them from cracking!!
Thank you for reading and/or downloading, please like (or boost :D) if you like it, and coment any issues you have. Ill attempt to fix them asap.
Check out my other part: https://makerworld.com/en/models/1143091#profileId-1145789
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (11)