Guitar Humidifer
Print Profile(1)
Bill of Materials
- Sponge x 1: 5x7x0.9cm
Description
A humidifier for acoustic and classical guitars.
This humidifier requires a sponge, which should be cut to size (approximately 5 x 7 x 0.9 cm). When using the humidifier, the sponge should be wet, but excess water squeezed out, so it doesn't drip inside the guitar. The humidifier is placed in between the 3rd and 4th string, and pushed in so that the strings are inside the notches on either side of the humidifier. This holds it in place.
Features
- String holder notches, allowing the guitar strings to hold the humidifier in place
- Strategically placed ventilation holes to ensure adequate humidification
- Simple push-fit attachment for the lid, resistant to breakage
Printing Notes
- The included print profile should have all the required settings
- Seam is placed in the back
- Variable layer height for the top layers of the humidifier body
- Supports were only used for the string holder notches
- I used Matte PLA
Boost Me (for free)
Thank you for your support!
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (20)