Print Profile(7)
Description
Boost Me (for free)
Like my models? Show your support with a Boost! Help me fund test prints and buy filament to create even more awesome designs. 🚀
An updated version is now available!
Updated new letters, Now avaiable "ITS MY LIFE", Comming the next days "OUR Journy" , for suggestions let me know in the Comment section.
Tested at 200 mm, 275 mm and 326 mm.
The 200 mm version was unable to hold the build plate.
Please Check if an LP can be held. As can be seen in the pictures, a small photo album can be held.
No support is needed, just a raft on the letters. For a tighter fit, decrease the tolerance; for me, 0.2 mm works perfectly.
Print time is even lower now!
Stability improved — hard to break!
I'm about to put new letters on it; just give me a few days.
The raft is easy to remove.
In some cases, it can be removed in one go by pulling on one of the ends.
If not, use a scraper, knife or something similar to slice at an angle as shown in the picture below.
License
You may create derivative works based on this object, provided that all such derivative works are published exclusively on the MakerWorld platform and include proper attribution to the original creator. You may not share, upload, host, distribute, or publish this object—or any derivative work of this object—on any other digital platform, marketplace, or distribution channel. Commercial use of this object and any derivative works is strictly prohibited. This includes, but is not limited to, selling, renting, sublicensing, or using the object in any context in which you receive monetary compensation or other financial benefits.
Comment & Rating (190)