Search models, users, collections, and posts
1/12 Rock wall
IP Report
Print Profile(1)
0.16mm layer, 2 walls, 10% infill
Designer
11.8 h
1 plate
Open in Bambu Studio
Boost
157
341
11
4
85
26
Released
Description
Boost Me (for free)
This is a rock wall made for my display and diorama for photoshoots. It is made in 1/12 scale, although at the smaller end. Would have liked to get it a little bit taller to fit in better with 1/12 scale. But I was limited by the size of the A1Mini. If you have a bigger printer it can easily be scaled up to fit well there. The figure used for scale is the Sentinel Miles Morales (around 13 cm).
The pictures are of a version printed on a 0.16 mm 0.4 nozzle, in ESUN Silver grey PLA.
It is printed with tree supports which did a good job and came of without issues.
In total for this size it was 210g of material with 10% infill.
Membership
Join
License
If you want to use this model commercially, please join my membership.
Join Now
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (11)