Ender 3V3 CoreXZ Light Bar

A fancy light bar for your Ender 3V3 CoreXZ!

Works with most LED strips out there. Easy to attach, easy to remove. 
I used standard WS2812B strips attached to a WLED controller. 
Don't trust the adhesive on the back of any led strip. They all suck. Use some thin double sided tape to keep it secure.

The only thing that needs support is model “Light Bar B”. Just paint on a tiny support as shown below. 

For the diffusers i used a clear PETG but you could just as well use anything else. It's quite thin and a fast print, so play around and see what you like best. 

The mounts have a small notch that helps you align and snap the pieces into place on the frame. If it snaps in place but slides down, you have it wrong. Pop it off and try again until held in place by the small notch lined up with the screw hole. You'll need 2 M3x8 screws of any kind to secure the mounts once they are positioned properly.
 

Enjoy!