Search models, users, collections, and posts
Needle file Holder for IKEA Skadis
IP Report
Print Profile(2)
0.2mm layer, 3 walls, 8% infill
Designer
1.4 h
2 plates
0.2mm layer, 3 walls, 8% infill
3.1 h
2 plates
Open in Bambu Studio
Boost
154
540
43
6
461
326
Released
Description
I wanted to mount the Needle files I have to Ikea Skadis board, Looking around there are many design but I liked Westeros Designs design as its practical and space saving, however, after printing; it didn't fit the files I have (I measured the handle on mine at 11.3mm wide) as the original ones had space for 10mm variety. So I went ahead and remixed the design while keeping the same design in place. Additionally I had some O-Ring Removers that are 15.2mm thickness so I made one that will fit them as will.
- 1st file resized to fit handles up to 11.5mm
- 2nd file resized to fit handles up to 15.5mm
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (43)