Speedybee Bee25 VTX SMA Antenna Mount

While the O4Pro's dual lollipop antennas are quite good, there's nothing wrong with upgrading to SMA antennas

Numerous Beecore frame solutions already exist, including Speedybee's own new Beecore frame, slated for release within three months

This mount allows for on-demand replacement of SMA antennas of varying lengths to suit different scenarios

During testing, I found TPU to be somewhat too flexible; PLA or PETG, or similar rigid materials, perform better

Model shared for personal use only; commercial use is strictly prohibited

Model shared for personal use only; commercial use is strictly prohibited

Model shared for personal use only; commercial use is strictly prohibited

——Update——————————

During installation, I discovered that the V1 antenna mount obstructed access to the rear mounting screw when installing the Beecore onto the frame

I have redesigned the V2 version, moving the antenna connector forward to provide clearance for the mounting screws, and have uploaded the new configuration file

A 5cm iPEX-to-SMA feedline is recommended

V3 version with a new configuration file is now available for download

In the V3 version, I have remade the mount model. While maintaining the aesthetic appeal of the V2 version, I have increased the thickness of the mount. PETG prints are now significantly more rigid, virtually unbreakable, and more robust; the model is also easier to print, resulting in a much higher success rate