Search models, users, collections, and posts
Slimmer Iowa Hawkeyes Magnet
Remixed by
IP Report
Print Profile(1)
0.16mm layer, 2 walls, 25% infill, Ironing, Flat top
Designer
43 min
1 plate
Open in Bambu Studio
Boost
27
72
8
5
135
84
Released
Description
This is a remix of the Iowa Hawkeyes Logo Magnet from Youngbru.
I wasn't personally a fan of the domed top, so I slimmed it down and made it flat (The logo is still raised off of main surface)
I made 4 top layers of yellow (using 0.16 optimal height). (AMS is required due to original domed shape and layers not being even).
Uses less than 12 grams of filament.
Added 2 holes on the bottom for 8mm x 2mm magnets (because I had them on hand), The other 4 holes remain too.
No support needed.
Quick 40 minute print (.16mm layer height)
Added ironing to all top layers for smooth top surface.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (8)