X-TRA Large Rugged container

Compatibility with Rugged Box System

• This box is equivalent to four medium rugged boxes.
• It can be attached above or below other rugged boxes.
• You can attach two medium rugged boxes to either the top or bottom of this unit.

Rugged Box System – Assembly Instructions

Required Hardware:

• 10x M3 x 10 socket head screws
• 2x M3 x 20 socket head screws
• 2x M3 x 16 socket head screws

Assembly Steps:

1. Attach the Handle
   • Secure the handle to the lid using two M3 x 10 screws.
   • Ensure the handle moves freely—if it’s too tight, add washers between the handle and the lid for adjustment.
2. Install the Front Clasps
   • Attach the two clasps to the front of the case using M3 x 20 screws.
   • Position the screws with their heads facing the edges of the case.
3. Attach the Hinges
   • Secure the hinges using two M3 x 16 screws.
   • Ensure the screw heads face the edges of the case.
4. Install the Side Clasps
   • Place each side clasp in the recess on top of the drawer unit, ensuring the holes are aligned.
   • Position the clasps with the flat side up in the cutout.
   • Use four M3 x 10 screws per clasp, threading them into the plastic of the main body.
   • Be careful not to over-tighten to avoid stripping the plastic, which could cause the screws to loosen over time.
   • Repeat for the remaining clasps.