Search models, users, collections, and posts
WERA Tool-Check 1 SB & Automotive *fold-out Guard*
IP Report
Print Profile(2)
0.16mm layer, 3 walls, 25% infill, Tree-Support
Designer
54 min
1 plate
0.2mm layer, 3 walls, 100% infill, ASA
Designer
54 min
1 plate
Open in Bambu Studio
Boost
14
59
6
5
58
44
Released
Description
UPDATE 20.09.2025
I add a new 3MF file in a newer Version v3.2
The part has been completely redesigned to create an even better, more stable version.
It is easier to print and thicker. This is better suited for craftsmen who work with it on a daily basis.
UPDATE 24.05.2025
I updated the STL and 3MF file.
The part showed weak points, these were revised again, the part was redesigned and the alignment was adjusted during printing.
I print in ASA 0,16mm layer.
I have created a fold-out protection for the WERA Tool-Check.
Please note that this can only be used for the SB 1 & Atomotive version.
Or all other where the hand screwdriver handle is NOT in the set!
They can simply replace this protection with the original slider on top.
License
This user content is licensed under a
Creative Commons Attribution-NoDerivatives
Comment & Rating (6)