Search models, users, collections, and posts
Scribing tool
IP Report
Print Profile(2)
PLA - 0.2mm layer, 4 walls, 15% infill
Designer
1.1 h
1 plate
PETG - 0.2mm layer, 4 walls, 15% infill
Designer
1.3 h
1 plate
Open in Bambu Studio
Boost
348
1163
101
59
1.8 k
1.4 k
Released
Description
This is a scribing tool. You can place a pencil through the hole and then scribe at 1/8" increments between 1/4 -1 inches. Great for carpentry, cabinet installing, construction, and general woodworking. I have included two print profiles: PLA and PETG. I measured a bunch of different pencils I had laying around and chose a hole size that worked the best. It's a nice snug fit for my pencils, but since not all pencils are the same, you may need to try different ones or reem out the hole if necessary.
I did not come up with this design. I have seen similar products for sale on Temu and Amazon I believe.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (101)