Search models, users, collections, and posts
Kitchen Cabinet Spray Bottle Holder
IP Report
Print Profile(1)
PETG, 0.2mm layer, 5 walls, 25% infill
Designer
1.2 h
1 plate
Open in Bambu Studio
Boost
153
458
21
12
294
222
Released
Description
Convenient hanger for spray bottles for the back of your kitchen cabinet door!
Simple quick print with minimal waste.
I recommend using PETG to get good strength for the mounts and the dowels.
Assembly instructions:
- All parts are printed on a single print bed (For P1 and X1)
- The dowel prints as an upper half and a lower half
- Assemble the upper half of the dowel to the lower half and insert through one of the hanger holes
- This fit is intended to be tight for strength. Insert both dowel halves the same time and push all the way through until it hits the stopper at the end of the rod
- Insert the second hanger at the other end of the rod and slide just past the stepped portion at the end of the rod
- Insert the end tap on the stepped end of the rod
- Slide the second hanger to the end of the rod, touching the end cap
- ROTATE THE ROD TO ORIENT THE ROD SUCH THAT THE SEAM BETWEEN THE “UPPER” AND “LOWER” ROD IS ORIENTED VERTICALLY - THE SEAM SERVES TO PROVIDE ADDITIONAL FLEXURAL STRENGTH TO SUPPORT WEIGHT.
Let me know if you have any questions or suggestions
Boost Me (for free)
License
This user content is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (21)